Creality 12v/24v Laser Adapter

This is a Remix. Go here for Adapter Part 1 --> https://www.thingiverse.com/thing:4656345

This Remix replaces Adapter Part 2 from the Original designer and poster. because I didn't have any extra screws to use, I just redesigned Part 2 to make it a Slip on Sleeve.

This Adapter will fit this Laser --> https://www.creality3dofficial.com/products/creality-blue-violet-light?_pos=1&_sid=554091e87&_ss=r

It was Designed to Fit that one, Not sure if it'll fit any others or not.

After spending about 6 hours Printing Part 2 of the adapter form the Original Designer, the Smaller cylinder slide broke right off without any resistance or pressure on it. And because i didn't have any Screws to mount it in place, i decided to Design my own that would slide in his Part 1 carriage mount.

So, all you've got to do is print this, Slide it on the back part of the laser with the bottom 6 holes open with no magnets or screws attached, then slide into part one after it's mounted.

if you don't have any screws, remove the 2 screws and magnets from the laser and use the screws to mount Part 1 to the Carriage, they work like a charm, perfect fit, just enough clearance to give you a snug fit.

I printed this with a .2mm Nozzle at .12mm Layers, Wanted to have a Descent looking mount as well as a little more stable with lower layer height.

You can print at whatever height you'd like, Also used 25% Infill (Lines).

Make sure Your ESTEPS and flow is calibrated correctly because if not, this won't fit, there is enough clearance to be slightly snug so there isn't no wiggling around while it moves, so make sure they are calibrated cause it WILL Fit the Laser as you can see in the photo, no sanding or anything required.

-