Flareon- EEVEE EVOLUTION-POKÉMON FIGURINE - 3D PRINT MODEL

This is "Flareon " from Pokémon series
I will be releasing my work on daily basis, some may even be free! so please follow and keep your eye on my updates !!cheers

PLEASE CHECK THEM OUT(OTHER 3D MODELS FROM THE SAME DESIGNER)!

Flareon is a mammalian, quadrupedal Pokémon covered in short, reddish-orange fur. It has long ears with black interiors, dark eyes, and a small black nose. There are three small toes and a yellow paw pad on each foot. Fluffy yellow fur forms a small tuft on its head, as well as its bushy tail and a mane around its chest and neck. It will fluff out its collar to cool down its high body temperature. This high temperature is caused by its internal flame sac. Flareon stores and heats inhaled air in this sac and then exhales it as fire. It is an omnivore that roasts either Berries or prey before consumption. Flareon is mostly found in populated areas and is rarely seen in the wilderness.

IF YOU ARE INTERESTED IN EEVEE EVOLUTION BELOW ARE SOME OF THE EEVEE EVOLUTION POKÉMON WE HAVE ATM, MORE IS COMING !

Espeon(Free)
https://cults3d.com/en/3d-model/game/free-espeon-pokemon-figurine-3d-print-model

Glaceon
https://cults3d.com/en/3d-model/game/glaceon-eevee-evolution-pokemon-figurine-3d-print-model-adamchai

Eevee(planter)
https://cults3d.com/en/3d-model/home/eevee-planter-pokemon-figurine-3d-print-model

Leafeon
https://cults3d.com/en/3d-model/game/leafeon-pokemon-3d-printable-figure

Umbreon
https://cults3d.com/en/3d-model/game/umbreon-pokemon-figurine-3d-print-model

Sylveon
https://cults3d.com/en/3d-model/game/sylveon-eevee-evolution-pokemon-figurine-3d-print-model

Vaporeon
https://cults3d.com/en/3d-model/game/vaporeon-eevee-evolution-pokemon-figurine-3d-print-model

Jolteon
https://cults3d.com/en/3d-model/game/jolteon-eevee-evolution-pokemon-figurine-3d-print-model

*This model require minor support to print with FDM .
*to have a better print result I would suggest to print this model in angle where the front surface facing upwards to avoid support structure in FDM prints, for DLP & SLA should be fine.