PRUSA I3 STABILIZER

Information about this project:

--

Experimental project based on an upgrade that greatly improved my impressions, but also, greatly reduced the vibrations of my Wanhao Duplicator I3 V2.1, just by using the project feet from Shorppy and installed anti-vibration foams for washing machines

So, I increased the contact surface of the Prusa's feet to install the same foams and I based myself on the form of attachment of bubu77 on the aluminum profile

Project follow-up:

--

• V0.0 : Creation

Hardware required:

--

• Anti-vibration foams

• M3 screws

• Insert M3

Additional information:

--

TEST_V0.0.stl : is to check the printing with your printer, otherwise, you can also print the 10mm foot to test

The 50 feet are for the 4 ends, and the 10 are for the front part against the printer frame

For the foams, you just need to cut them to the right size with the two parts and glue just on the larger one, or cut two strips

UPDATE :

--

• 2019/11/18 :

  • Project creation (V0.0)
  • STL and project photo added (V0.0)

---

Information about this project :

--

Experimental project based on an upgrade that greatly improved my impressions, but also greatly reduced the vibrations of my Wanhao Duplicator I3 V2.1, just by using the feet of the project Shorppy and installed anti-vibration foams for washing machines

So, I increased the contact area of the Prusa's feet to install the same foams and I relied on the fixing form of bubu77 on the aluminum profile

Project follow up :

--

• V0.0: Creation

Necessary material :

--

• Anti-vibration foams

• Screw M3

• Insert M3

Additional information :

--

TEST_V0.0.stl: is to check the printing with your printer, otherwise you can also print the 10mm foot to test

The feet of 50 are for the 4 ends, and the 10 are for the front part against the frame of the printer

For foams, just cut them to the right size with both sides and just stick to the larger one, or cut two strips

UPDATE :

--

• 2019/11/18 :

  • Creation of the project (V0.0)
  • Addition of the STL and photo of the project (V0.0)

-