AN ACTUAL CENTER FINDER THAT WORKS.

DO YOU KNOW HOW ANNOYING IT IS TO FIND A CENTER FINDER THAT WORKS?
YOU KNOW, ONE WHERE THE DESIGNER TOOK INTO CONSIDERATION THE WIDTH OF THE WRITING UTENSIL TO FIND THE CENTER? OR TO BRACE THAT CENTER BAR TO DRAW AGAINST THAT WONT MOVE?

IM WRITING IN CAPS BECAUSE I WAS FRUSTRATED WITH THE FACT I WAS PRINTING CENTER FINDERS AND MY CENTERS WERE NOT ON CENTER. IT WAS VISIBLY NOT CENTER. WHICH IS WHAT I COULD HAVE DONE WITHOUT PRINTING ONE OF THESE FOR AN HOUR AND WASTING FILAMENT I COULD BE USING FOR PRINTS FOR MY GIJOES. THIS IS THE CENTERFINDER YOU SHOULD BE USING. ARE YOU A MAN?

HERE'S WHAT THIS IS:

offset from center for .9mm lead literally taken a set of calipers to .9mm mechanical pencil lead. good luck finding any of these if you want to find the center of a flat circle and not a dowel. put that in your pipe and smoke it. ARE YOU A MAN? you should be using .9mm lead mechanical pencils in your shop. instead of me telling you this you should be like "HELL YES IM A MAN, I HAVE LIKE 5 .9MM LEAD MECHANICAL PENCILS IN MY GARAGE RIGHT NOW! LOOK AT MY BURLY CHEST HAIR." i cant tell you where any of them are at though, because what kind of real man puts anything right back where it belongs if you're going to use it again later?

got a small circle? now you can see where it hits the other side of the 90degree angle. what do you think of them apples? they're good. i know. eat one. "WHAT? NONE OF THESE CENTER FINDERS EVEN THOUGHT OF THAT. WHAT IN THE WORLD!?"

"what if the middle snaps off because of that gap to see the small circle?" no. that's braced. enjoy that apple you DUMB DUMB.

GUESS WHAT ELSE IS BRACED? that center bar you have to trace against, go ahead and find one that does that. you wont. and ALL YOUR CIRCLES ARENT CENTER BECAUSE OF IT YOU DINGBAT.

if i feel like making .5mm and .7mm versions of those types of lead, then this will show it's size. hopefully you can read. if you cant it's raised so you can feel it's soft luxurious numerical value. if you cant read, you probably cant read any of this at all. but those of you who can, and if i ever want to find the center of a dowel and use .5mm and .7mm lead, for whatever reason i'll probably even update it for that nonsense too.

you're welcome.
dont sell my design. dont sell prints of my design. be a man. not a shitbag.

-