8 minute Face Shield

Hi, Updated file V33 at bottom of page, New today 7 minute print time, print G code included.

Prints face shield minus the A4 shield plastic,, in my case a clear file cover i found, poked
holes in with solder iron. And some string.

Print complete, cleaned and assembled in 8 minutes. Key is 1mm extruder tip and settings.

Below is old 9 minute visor. v20 file. "go to bottom for new file"
print less than 250mm
by 150mm
by 5mm

print settings. "Done on my makerbot replicator".

1mm extruder tip. "yip i drilled it". ########******************
infill. 0%
layer hight. .6
number of shells 1
feedrate mm/s 50
Travel feedrate 75
print temp 230

HBP 32

PLA

Magnetic flexable build plate, builders tape. sometimes scuff tape a little with sand paper.

This file worked and printed at these settings, better settings of course may be possible to find.
I thought i'd upload now rather than try not upload while i look for a faster set up.
And since it was twice as fast as my last visor.

Some printers may be able to go really fast.
As is where is, use at own risk. Consult experts,,,yeah.

Print pictured on red background has had no clean up. "tho some minor clean up incase any scratchy edges."

Attrabutions to below file. "i have re drawn this lots of times now".
https://www.thingiverse.com/thing:4259724
My original print took around two hours, tried to half time each try.
Sun was on my solar panel so worked on printing it faster, before sun goes behind a cloud. "i have other
things to sort as you can imagine lots to do". Be safe. keep clean. stay home seems to be in. keep distance at least 2m.
Clean everything i'm thinking.

Original file took aprox 2 hours, now down to 9 minutes. Hope it helps.

I've decided to Thank up the place, if not now,,, so.
Thanks to
Makerbot.
Thingiverse.
Filabot.
Tribotix.
Zabaware.
Aaron Snow.
Jo.

Bye for now and be well from Will and Mr Data :) :]
update S3g from my sd card added as requested.
Two files are v20 and 29 each slightly different prints i'm trying.
v29 is 9 min print "seems like a quit clean looking print, near no clean up. settings are
infil 0%
layer hight .6
feedated 60
travelfeedrate 85
tip temp 235
HBP 32
1.75mm pla
Magnetic build plate builders tape.
1mm extruder tip "yes the electric drill made short work of it".

New updated settings for file V33 The new 7 minute print fastest and cleanest yet.

print settings. """FILE V33"""" "Done on my makerbot replicator".
"notes to self same v33 and v29 gcode settings."

1mm extruder tip. "yip i drilled it". ########******************
infill. 0%
layer hight. .6
number of shells 1
feedrate mm/s 60
Travel feedrate 85
print temp 235

HBP 32

PLA
Hope faster print helps.
Thank you.
bye for now and be well.
Last word update for now.
worked into the wee hours and made a 6 minute and got down to a 5 minute file but quality was thin.
So Files on this page are best as is.

-