A new cigarette rolling machine, also rolls cone cigarettes

Cigarette rolling machine, also rolls cone cigarettes, straight cigarettes can be rolled in 5mm / 6mm / 7mm sizes and cone cigarettes in all combinations from 5mm-6mm-7mm. When the tensioner is up, this is the large size of the cigarette.By sliding a tensioner on one side of the machin,A cone cigarette is obtained,There is a video link on how to roll, and there are also detailed assembly instructions.link to 2.5 mm rod-https://www.amazon.com/uxcell-2-5mm-Diameter-Stainless-Subject/dp/B088K2MPCB\\\\link for magnet 5mm-https://www.first4magnets.com/circular-disc-rod-c34/5mm-dia-x-1-5mm-thick-n42-neodymium-magnet-0-46kg-pull-p6636#ps_0_6833|ps_1_6829 \\ link for screw----- https://www.grainger.com/product/GRAINGER-APPROVED-M2-5-0-45mm-Machine-Screw-6HB68 \\\\\\\\\\\\\\for more design----------https://cults3d.com/en/users/ilankaplan84/creations

There is an attached picture of printing directions, I print relatively low resolution (you can print at a lower layer height and get a better result) It is recommended to give a lot of filling or even 100% filling if you really want to work with the machine so the plastic will be stronger. \\\ Layer height -0.3 \\ Print speed -60 - \\\You need a 2.5mm diameter iron rod, three units - 90.6mm \\\ 78mm \\\ 90mm \\ There is an attached link to a site where you can buy them or you can cut them from an old barbecue net. (There is an attached photo) \ \\\\\\ need - magnet diameter 5 mm \ thickness 1.5 mm - there is a link to the site or you can take them from rolling paper GIZEH) There is an attached picture, \\\ screws --- length 10 mm \ Diameter 3mm \ Diameter of screw head 5-6mm, need 6 units, (there is a link to the site for purchase.