Bumper Fake Gatling Gun, prop, 100% Support free

NOTE: COPYRIGHT PA1© - SUBSCRIBE TO MY PATREON TO GET ALL (YES ALL!!) MY FILES FOR FREE, EXCLUSIVE MODELS AND A COMMERCIAL LICENSE TO SELL YOUR PRINTS:

https://www.patreon.com/PA1_MAKER

Disclaimer: Do not use on the road. Mostly good for offroad, meets, car shows etc. Not responsible if you get in any trouble with this using it

Bumper gatling gun i made for my old Xterra.

VEEEEEERY easy to print. Multiparts, everything lays flat on the bed with zero supports needed.

The base is slightly cutted in an angle to suit my xterra fog light housing. I have included a set of different spacers if you need to change the angle of the main mount. Simply put the correct spacers behind the mount and screw them in place with self tapping screws, or any other way you want.

IMPORTANT: Choose canon Pt002 OR Pt003. Not both. They are not the same height, so you choose depending of the look you want. But if you put both, spacing wont be regular. You can put as many plates as you want, as long as they are the same, Pt002 or Pt003. ;)

After glueing all the rest together, install the main assembly on the mount already installed on your vehicle. And there it is! That's it!

I used m4x12 screws to secure the assembly in place, with the provided holes on the mount/base.

You can scale the whole thing the size you want to accomodate your vehicle.

Hope you like it! If yes, leave a like, post your make and share the link!! :p

Thx!! Happy printing!!!!

NO COMMERCIAL USE ALLOWED

Did this one with 0.3 layer thickness to gain time. Its an easy print, so almost every settings will work. I recommend flat black material.