FPV DRONE STAND (3 UP TO 5 INCH)

This is a light and stylish stand for drones. The structure is subdivided into three components that can be printed apart. The base and the main column can be just snapped in or glued (it depends on how good you are in managing tolerances) and the base has a housing for a 3M conic head screw that goes directly in the center. To block the drone you can use the holes on the top to insert two columns (the common one used to assembly the drones are good for this). The models are all high poly so, in case you want to scale it is still possible.

PS: the transparent drone into the preview is not into the project files!

In case of any need, please give me a contact any time! (Name of the STL files is not correct, I will update it from "5inch" to "4inch" asap: personally I use it for 5 inch as well).

TAG: drone, fpv, stand, backeca, show, collection, tbs, drone, support, diatone eachine, freestyle, racer, race, long range, cinewoop, iflight, nazgul, roma, fatshark, fat shark, quadcopter, quad, crossfire, dji, goggles, green hornet, falcon, lipo, gopro

To get an amazing finishing on the surfaces I always suggest maintaining a speed of 45mm/s when the inclination of the object is about 40 degrees. More in detail:

Base:
Wall thicknes 2 mm
Infil 40%
Support NO

Column:
Wall thicknes 3 mm
Infil 0%
Support Only at the base (put it in vertical position)

Head:
Wall ticknes 2 mm
Infil 40%
Support NO