Midas m32 supports for phone, ipad/Tablet and microphones

Set of mounts for mobile phones, ipad , microphones and access point wifi ( ubiquiti, tplink cpe510...) designed for the Midas m32 mixing console.

The stand for ipad and tablets is designed in three sizes according to the thickness of your device with or without case. (only the width of the area that holds the tablet changes)

small 1.2 cm

medium 1.5cm

big 1.7cm

The phone holder allows you to put it vertically or horizontally.

The microphone holder is designed to put a measuring microphone type ecm800 and a talback type sm58.

Ap wifi can be mounted horizontally or vertically.

You can use adhesive rubber to improve the grip of the devices to the mount and the mount to the m32. You can also put a magnet piece to the base to get a better fixation to the m32.

The rubber can be 1 or 2 millimeters wide.

Set of holders for mobile, iPad, microphones and wifi access point ( ubitiqui m5, tplink cpe510...) designed for Midas m32 mixing desk.

The iPad and tablet stand is designed in three sizes depending on the thickness of your device and whether or not it has a case (only the width of the area that holds the tablet changes).

small 1.2 cm

medium 1.5cm

big 1.7cm

The phone holder allows you to place it vertically or horizontally.

The microphone holder is designed to hold an ecm800 type microphone and a sm58 type talback.

The access point holder can be mounted horizontally or vertically.

You can use adhesive rubber to improve the grip of the devices to the stand and the stand to the m32 and also attach a magnet to the base of the accessories to fix it to the table more solidly.

The rubber can be 1 or 2 millimeters wide.

Petg or PLA

50% infill

no supports ( mic clips needs support)

the mic clips can be glued (CA) or screwed to the base