Wishiwashi - FAN ART - POKÉMON FIGURINE - 3D PRINT MODEL

This is "Wishiwashi" from Pokémon series
I will be releasing my work on daily basis, some may even be free! so please follow and keep your eye on my updates !!cheers

PLEASE CHECK THEM OUT(OTHER 3D MODELS FROM THE SAME DESIGNER)!

Wishiwashi is a fishlike Pokémon. It has two different forms depending on the situation.

In its Solo Form, Wishiwashi resembles a small fish. It has large, light blue eyes with irises that resemble puddles of water and dark blue eyelids. The head and tail are both white. There is a line of white teardrop-shapes on each side of its body with the teardrop nearest the head being slightly larger. The top half of its body is dark blue and has a short, rounded dorsal fin. The lower half of its body is gray with two pectoral fins. This tiny Pokémon is both the shortest and lightest Water-type.

In its School Form, Wishiwashi resembles a large fish roughly formed from various smaller fish with glowing eyes. Starting with its head, its body is divided into four bands that each becomes a slightly darker shade of blue. A ring of bright blue glowing spots lines the front edge of the two middle bands. The centers of its "eyes" are formed by a single white fish with glowing eyes for pupils. Surrounding the white fish is a dark blue recess, and at the rear edge of the "eye" is a raised white area for eyelids. Above each eye is a single, dark blue fish shape. Wishiwashi's mouth gapes wide open, apparently unable to close fully due to gaps on each side. Its lips in the front are lined with glowing spots, and many more spots dot the inside of its mouth.

*This model require minor support to print with FDM .
*to have a better print result I would suggest to print this model in angle where the front surface facing upwards to avoid support structure in FDM prints, for DLP & SLA should be fine.