MANUAL TURNTABLE

Manual turntable with which we can photograph and make 360 videos of our creations or paint models and parts.

I have added three plates (print the one you prefer) of 120mm, 180mm and 200mm and a base in two pieces that are joined with 2 plastic flanges, so you can print on printers 200x200 or higher.

The knob has a cam that slides out to facilitate full turns.

Once mounted it needs to be attached, for example, with a few screws, glued with double-sided tape or hot silicone, to a surface so that it will not move when turning.

Assembly is very easy, simply by going by the pictures posted, but I will address any questions in the comments.

I recommend not modifying the dimensions.

In the parts list I indicate, for each part, whether supports are necessary, the number of parts to be printed and the orientation I have used.

If the printer is properly calibrated there should be no problem for it to work properly.

The gears are attached to the base using clips. It is recommended that the clips rotate freely in their housings. It may be necessary to sand the grooves of the gear shafts a little to achieve this.(depends on how the seams and remains of the brackets are left).

PARTS LIST:

1.- stl-plato-120- DO NOT MODIFY ORIENTATION - SUPPORTS NO

2.- stl-base-part-plate- DO NOT CHANGE ORIENTATION - SUPPORTS NO

3.- stl-base-part-command- DO NOT CHANGE ORIENTATION - NO SUPPORTS

4.- stl-base- MODIFY ROTATION IF NECESSARY-SUPPORTS NO

5.- stl-plato-180- DO NOT MODIFY ORIENTATION - SUPPORTS NO

6.- stl-plato-200- NO CHANGE ORIENTATION - SUPPORTS NO

7.- stl-clip-sop-sop-eng-plato (x3)- PRINT 3 - DO NOT CHANGE ORIENTATION - SUPPORTS NO

8.- stl-sop-eng-plato- RECOMMENDED ORIENTATION - YES SUPPORTS

9.- stl-clip-corona- NO CHANGE ORIENTATION - SUPPORTS NO

10.- stl-clip-eng (x6)- PRINT 6 - DO NOT MODIFY ORIENTATION - SUPPORTS NO

11.- stl-corona- RECOMMENDED ORIENTATION - YES SUPPORTS

12.- stl-eng-1-2-3-4 (x4)- PRINT 4 - RECOMMENDED ORIENTATION - SUPPORTS YES

13.- stl-eng-5- RECOMMENDED ORIENTATION - SUPPORTS IF

14.- stl-eng-command- RECOMMENDED ORIENTATION - YES SUPPORTS

15.- stl-eng-plato- RECOMMENDED ORIENTATION - YES SUPPORTS

16.- stl-eng-box-command- RECOMMENDED ORIENTATION - YES SUPPORTS

17.- stl-clip-box (x2)- PRINT 2 - DO NOT CHANGE ORIENTATION - NO SUPPORTS

18.- stl-clip-eng-plato- DO NOT CHANGE ORIENTATION - SUPPORTS NO

19.- stl-clip-leva-command- DO NOT CHANGE ORIENTATION - SUPPORTS NO

20.- stl-clip-cam-command- RECOMMENDED ORIENTATION - YES SUPPORTS

I will address any questions in the comments.

In the spirit of improving my work, I would appreciate it if you rate the quality of the creation.

Thank you for your attention.

Layer: 0.2

Supports: Yes

Backfill: 20-30%.

Speed: 40 mm/s (recommended for PETG)

PLA 210º Bed: 60º

PETG 235 Bed: 92º (recommended)

I will address any questions in the comments.

Thank you for your attention.