10 MCP Character Card Holders

NOTICE: THIS IS A DIGITAL STL FILE TO BE USED FOR 3D PRINTING. THIS IS NOT A PHYSICAL PRODUCT.

These card holders were designed to hold 10 or 11 sleeved (top-loader) character cards for Marvel Crisis Protocol.
The all-in-one tournament edition holds additional sleeved cards in the back as well:
- 6 objective cards
- 3 objective maps
- 8 tactic cards

The modular magnetic back can also hold 17 sleeved (Dragon Sleeves) cards.

The files included can be scaled to fit other sized cards and sleeves.

The product images in the pictures may slightly differ from the product you print. You may see slight flaws in the print and areas on the print may be sharp. Each character card holder printed should be carefully inspected before use.

The STL Bundle will include access to the following files in a zipped folder:
- 10 Character Cards Holder (Standard Edition)
- 10 Character Cards Holder (Standard Tournament Edition)
- 10 Character Cards Holder (Magnetic Standard Edition)
- 10 Character Cards Holder (Magnetic Tournament Edition)
- 11 Character Cards Holder (Magnetic Standard Modular Back)
- 11 Character Cards Holder (Magnetic Standard Edition)
- 11 Character Cards Holder (Magnetic Tournament Edition)
- 17 Tactic Cards Holder (Modular Back Accessory)
- 3 Different Tool Holders (Modular Back Accessories for Cog'o'Two Tools)
- 1 Core Box Tool Holder (MCP Label)
- Magnetic Lids
- Standard Lids

Legal Notice: Marvel is a trademark of Marvel/Disney and Marvel Crisis Protocol is produced by Atomic Mass Games and distributed by Asmodee. This product and I are in no way associated with Marvel/Disney or Atomic Mass Games and this is work of my own design and making.

*The purchase of these files does not give the owner permission to resell any of the files or products created from the files. If you would like to sell finished product, please contact the Etsy store owner for inquires.

Print at 0.16 - 0.2 layer height
Infill 10-20%
Print standing up with base of cardholder on build-plate
No supports needed
May want to use brim for best adhesion and less warping

5mm (D) x 3mm (H) magnets are recommended with a dot of super glue for the magnetic versions of the card holders and lid. Smaller magnets should work too.