Star Wars Purge Trooper Helmet 3D Printable Model 3D print model

Ready to print Star Wars Purge Trooper Helmet 3D model (digital file).

You can see my models after printing here: https://www.instagram.com/sonndersmith/

You need at least 220 x 210 x 200 mm build volume to print the mask. Contact me if your printer is smaller and I’ll split the files up according to your parameters.

Average wall thickness of each big part has an optimal value for resin casting: 4-5 mm.

I don’t mind if you’re going to sell masks made using my models, all I want from you is tagging me on Instagram in your relevant posts (@sonndersmith).

Listing contains:

• printable files in OBJ format;
• printable files in STL format;

• low poly model of inner surface of the mask* in PDO format.

• Before 3D printing you can check the mask size by making a low poly version of it out of paper using Pepakura. If the paper mask fits to your head well, you may print the file, if not, try to change its size at a certain percentage and when you find the proper value just use the same percentage for 3D printing. This approach will help you to save a lot of filament and time.

The mask model is scaled for an average 57 cm girth head, but the size could be changed if necessary.

There're two models of templates for making metal mesh pieces (you can print them on a paper using Pepakura as well). Meshes are placed into the helmet from inside into special recesses.

Contact me if you have any questions.