Tyrannis Decepticon Shield 3D print model

After arming the Autobots with the Libertas shield, balance needed to be restored in the cosmos and we bestowed the Tyrannis Decepticon Shield on the opposing faction!

Similar to its counterpart, the Tyrannis Shield transforms from an imposing shield which is carried by the Decepticon warrior into combat, to an attack drone to further boost the Decepticons' air superiority! The buzz of an entire swarm of these drones are sure to dissuade any bots from advancing further. Siege effects can be added on to give the drone an additional boost.

In cases where stealth is more the name of the game, an alt mode of a much smaller recon drone which is launched from a base station can be used.

When all goes badly in combat (as it oft does!), it may just come back down to melee combat, so using the top portions of the shield allows for multiple spear configurations:

There will be an assortment of 4mm and 5mm rods required to peg the parts together. The lengths of which are shown in the attached diagram.

And there you have it - the Tyrannis Decepticon Shield, all ready to arm your cons with.

===

This model is not to be uploaded or sold in any form and is intended for personal use only.

Check out more of what we are up to over at our Facebook Page (http://www.facebook.com/FunbieStudios) or website (http:/www.FunbieStudios.com)

Support us on Patreon - https://www.patreon.com/FunbieStudios