Card Deck Wall Mount

This is designed to be printed in multiple prints on a small bed 150x150. Everything lays flat with minimal supports.

The mount can either be mounted to a wall with 3 screws or it can stand on it's own on a desk. Hold 40 standard decks of cards. Very easy print and assembly.

All holes in back plates requires to be cut out. The holes are there but were made solid for ease and uniformity of printing without supports.

Items to print:
1 - each back plate total 6 pieces
4 - Top Left Wall
4 - Top Right Wall
4 - Bottom Left Wall
4 - Bottom Right Wall
40 - Shelf

Hardware Needed:
32 - M3x25 screws
32 - M3 Hex Nuts
3 - M3x5 (Note: These will protrude through back but its by design)

Assembly:
1 - Assemble left center and right sections together.
For Desk Stand
2 - Slip shelves into grooves with the lip at the back.
3 - Insert card decks and enjoy.
For Wall Mount
2 - Mount ONLY center section in desired position on wall.
3 - Level center section.
4 - While maintaining center level, place left or right section to the side of center section.
5 - Fasten attached with screw as center as possibly to eliminate drooping.
6 - Repeat 4-5 for other side.
7 - Slip shelves into grooves with the lip at the back.
8 - Insert card decks and enjoy.

Printed with 0.4mm nozzle at 0.2mm layer height. External supports only needed for wall over hangs.