Suspended Spherical Succulent Splanters (Planters)

Hang your succulents or air plants in these hanging planters. There are four versions of the sphere:

-The 1-hole planter only has a top hole and is designed to hang alone…or at the bottom of your multi-part creation.

-The 2-hole planter has the top hole and one in the bottom-center. It is designed so you can hang a second planter directly below the first. Note that if you overwater this planter, some of the water may leak out the bottom hole and run down the string to your next planter.

-The 3-hole planter has the top mounting hole and two on the sides. There is no bottom-center hole, so this planter doesn’t have a water leakage problem that the 2-hole version does.

-The 4-hole planter has…you guessed it!..the top hole and three on the sides. You could use this version to hang three planters below this one.
Use string, fishing line, yarn, etc. to hang one sphere from another…and mix-and-match various spheres to make more complex creations.
For simplicity, I’ve included a set of four small printable rings. These are just meant to be used to secure any string on the inside of each planter. Of course, anything would do…a scrap of filament, a small piece of wood, or even a really big knot at the end of the string. It’s your choice.

I've also included a small, matching "watering sphere" (watering can). As with other parts of this design, it does NOT need supports when printing.

Print as few or as many planters as you want to create a hanging garden. If you’d like me to share your creation in this listing, please send me a picture. My email address can be found in my creator profile linked below. I’ll then update the listing and include your photo.

Standard infill (20%) and other print settings should be sufficient. There is NO need for supports: these print quite well as-is.