Kawaii Cat with a Planter Box

Kawaii Box with a Playful Cat Plant Holder

This adorable cat will try to reach out to the plant in the cardboard box. Can't be cuter than that!

Guaranteed 100% Kawaii! (✿◠‿◠)

There are 2 different boxes. One with drainage holes and one w
ithout.
Use a point of glue to insert the face elements of the cat.
⭐⭐⭐⭐⭐
IMPORTANT NOTE:
If you want to sell 3D prints based on my designs legally, please become a supporter on the Thangs Membership:
🔵Thangs - Membership

All my Designs are covered by a Creative Commons Non-Commercial License on Cults 3D. The sale of prints using my designs is the sole right of myself, the designer, and my active supporters to do so. Please understand every design is many days of work and multiple prototype prints to ensure quality.

Happy printing!

To get the best out of the STL file, please follow these guidelines:
• Layer Height 0.2mm
• Supports are needed! Please, take a look at the pictures.
• Nozzle 0.4mm
• Recommended infill 20%.
• Do not print over 50 mm/s. A lower speed like 40 or even 30 mm/s will always produce better results.
• Make sure your bed is correctly leveled. Then check again :D
• Try to hide the seam and place it where nobody will pay attention.
• Make sure your printing temperature and bed temperature is adequate for the filament you are about to use.

Please, tag me on Instagram (@Holoprops). I would be thrilled to see your results in all kinds of colors.

Happy printing!