MicroSwiss Direct Drive Fan Shroud -- NoothGroosh Cooling -- Ender3v2, EnderPro, Ender3, MicroSwiss Direct Drive + CrTouch/BlTouch Compatible

DONT FORGET TO UPLOAD YOUR MAKE! :]

*UPDATE 2021-01-02 *
new version uploaded which entirely resolves the issues mentioned below. The cr/bl touch main is offset by x-10, which should make the total probe offset for this set up:
Probe X Offset: - 54.0
Probe Y Offset: - 07.0

Additionally, the cr/bl touch mount is 1mm closer to the bed compared to the stock mounting bracket. I made this change because, with the stock mounting bracket, the point at which the cr/bl touch detects a surface always resulted in the nozzle crashing into the bed. Ever since adjusting the mounting location, the nozzle hasn't touched the bed once.

*UPDATE 2021-01-01 *
I'll be pushing a new version of this duct soon as the current version may result in cooling the thermistor and causing a "thermal runaway" error to get thrown. Others might not experience this, but mine did. As a result, I've modified the height/distance of the duct ports to prevent a silicone sock from deflecting airflow into the thermistor.

This duct is intended to be used with the Ender3v2, with microswiss direct drive and a crtouch/bltouch. The duct utilizes two 40mm fans. For the parts cooling fan, I'm using a 40x28mm fan running at 16,000 rpm which is probably overkill for this application. The heatbreak fan is just a standard 40x10mm but any 40mm fan should work here. I've included a file for a 40mm tpu gasket. I'm primarily using this for vibration dampening on the 40x28 snowfan.

All holes are intended to be used with m3 hardware.

Important note: offset bltouch/crtouch an additional X-10