Teddiursa Ursaring Ursaluna Evolution - FAN ART - POKÉMON FIGURINE -POKEMON LEGENDS ARCEUS

This is "Teddiursa Ursaring Ursaluna Evolution" from Pokemon Legends Arceus series
I will be releasing my work on daily basis, some may even be free! so please follow and keep your eye on my updates !!cheers

PLEASE CHECK THEM OUT(OTHER 3D MODELS FROM THE SAME DESIGNER)!

Teddiursa is a bipedal, ursine Pokémon covered in short, orange-brown fur. Its muzzle is a light tan color with a small black nose and black eyes with white irises. There is a slightly paler tan crescent marking on its face, and it has round ears. It has three claws on its forepaws as well as two claws and yellow paw pads on its hind paws. Its tail is short, round, and puffy.

Ursaluna is a large, quadrupedal dark brown bear Pokémon with a grey pelt around its back, paws, and round tail. The grey pelt has 9 rectangle brown spikes on its back and four spikes on each side of its head. The front paws have five claws each while the back paws have three claws. The face is brown with a light yellow circle at the center and a light yellow snout with a small black nose.

Ursaring is a bipedal, ursine Pokémon. Its broad body is covered in brown fur, except its muzzle, inner ears, and paw pads, which are a light tan. It has narrow eyes, a triangular, black nose, and a wide mouth with small, visible fangs in the upper jaw. The fur on Ursaring's shoulders is longer and more structured, with rectangular extensions that resemble epaulettes. A female Ursaring has longer fur on its shoulders than a male. There is a large, tan, ring-shaped mark on its chest. Ursaring's forelimbs are long, ending in five claws each, while its hind legs are short and thick, ending in three claws each. Its tail is large and spherical in shape.

*This model require minor support to print with FDM .
*to have a better print result I would suggest to print this model in angle where the front surface facing upwards to avoid support structure in FDM prints, for DLP & SLA should be fine.