protection for fishing stand

simple and effective protection of the sharp ends of fishing stand . Prevents puncturing the bottom of your backpack, bag.

It is a cube with 4 holes ( the 3d model has 9,3mm for each hole) Pote there are 2 more holes around them. Into this cube is pushed four fishing stand (don't be afraid to push them in ).From the second side of the cube a rope or some kind of cord is pushed through and pulled over fishing stands.
For this pressing of the holder to the cube you can certainly use some longer rubber or whatever :P

new update : fishing stand protection small version
new : 100mm long version

All my fishing equipment

https://cults3d.com/en/design-collections/BIONICFACTORY/fishing-equipment

100% infill 99 walls
3 bottom layer
3 top layer
0,28 - 0,30 mm layer height
pla - 200C- 210 C
support - no

If you want holes for your larger fishing supports, in the slicer if you increase the size of the hug by 10% the holes will be 0.93 mm larger, 9.3 mm + 0.93m = 10.23 .

But I recommend to always give at least 1 mm extra margin.

I have created 2 versions . one has extra thin profiles underneath which prevent any bounce from the pad due to the fact that at 100% fill there is tension in the plastic .These sticks just need to be removed after printing with pliers