Australian picnic table

This is a replica of an Australian picnic table which can be found in many natural parks all over the country. These picnic tables are of high quality and are very comfortable to sit at. They are constructed out of wood or of recycled plastic. This type of table sits four people.

The table top is 13.3 cm (5.2 inches) by 6.3 cm (2.5 inches) in size. The table is 6.3 cm (2.5 inches) high. The table consists of a lot of planks and pins. The pins and holes make it easier to glue the parts together.

When all parts are printed, they must be glued together. I have created an assembly guide for the picnic table as a PDF document which you may want to download here:

https://www.dreamtime24.de/Thingiverse/Dreamtime24_Picnic_Table_assembly_guide_Rev01.pdf

You can print the table planks in a brown color to simulate wood. The pins can be printed in a black color.

Please note the following list describing how often the STL files need to be printed.

• Table pin V1.stl
  Print this item 40 times. 35 pins are needed, but some spare pins are nice to have.

• Table seat planks V1.stl
  Print this item twice.

• Table seat support V1.stl
  Print this item twice.

• Table side 1 V1.stl
  Print this item twice.

• Table side 2 V1.stl
  Print this item twice.

• Table support V1.stl
  Print this item once.

• Table top planks V1.stl
  Print this item once.

• Table top support V1.stl
  Print this item once. Position the pins in a vertical position on the printer's build plate.

Enjoy printing these items.

Amusez-vous à imprimer ces objets.

0.2 mm initial layer height, 0.2 mm layer height. No supports required. 20 % infill.

The orientation of all items in the STL files should be already fine. Only the pin has to be rotated to stand upright. If a plank has holes, they are facing upwards.