Hadara organizers

Organizers for Hadara board game. They provide quick game set up and comfort during the play.

The set contains: coin organizer, card tray, colony organizer, marker organizer and container for marker organizers.

1. COIN ORGANIZER: Very useful organizer for 4 different types of coins, 10-value markers and gold medals. As usually, I suggest printing 2 of such containers, so they can be placed on 2 sides of the table. Thus all players can easily reach for these items. All sections have rounded bottom to facilitate item draw.
2. CARD TRAY: There are 15 decks in Hadara. They can be accommodated in 3 of my card trays - each epoch separately. They have sloped bottom and indentation to facilitate card draw. Card trays are very helpful both in the game set up and during the play - when you discard the card, you just place it on the right deck. In the beginning of the new epoch put in front the current tray. (It is designed for cards without sleeves).
3. COLONY ORGANIZER: All colony tiles are separated by their value in 5 decks in colony organizer. It is thoroughly designed, so it's tough enough, tiles fit their sections very well and indentations facilitate the draw.
4. MARKER ORGANIZER: For each player there's a marker organizer. It's a long plate that can be placed above the player board during the play. Thoroughly shaped recesses stabilize all bonus tiles and wooden markers. Still all items are very easy to take out.
5. CONTAINER FOR MARKER ORGANIZERS: A container that accommodates all 5 marker organizers. It is thoroughly shaped to stabilize all plates and to provide easy access to them, so taking them out is comfortable. There are additionally 2 slots. In one of them I keep setup cards. In the second - items from expansions could be held. Rounded indentations facilitate taking items out.

All organizers fit the game box very well and provide quick game setup. However it's not an insert.

Some photos in higher resolution:
The set
Game set up for 4 players
Card trays
Colony organizer
Marker organizers
Container for marker organizers
Packing 1
Packing 2
Packing 3

All organizers were 3Dprinted on Prusa MK3:
- in PLA,
- No support is needed,
- Infill 10% rectilinear.
Note1: I use slightly changed default Print settings "0.15mm SPEED MK3" in PrusaSlicer.
Note2: Card tray is 237.5 mm long. It fits Prusa MK3, but it's close to its limit. Such a tray, but for cards with sleeves would be too long.

Printing Time (for one organizer of each kind):
01: 4h53' (x2) (layer height 0.2mm)
02: 4h23' (x3)
03: 3h44' (x1) (infill 15%)
04: 1h37' (x5)
05: 5h5' (x1) (layer height 0.2mm)