BMW Series 3 E90/91/92/93 Cup Holder Inside The Armrest

Cup holder for 2 cups of coffee or a tin of soda.

Fits the armrest with a simple mat. All you have to do is to take the rubber mat out.
Fits the one with phone adapter too. The adapter of course must be removed as well.
Here is the Youtube link to help you.
https://www.youtube.com/watch?v=qEqWoIeQzKk

This cup holder is made on the supporting legs. It is recommended to apply a double sided tape (gel tape of any brand) on the bottom part for it to hold in place firmly.
Some say they didn't need the tape, but it is still better doing it to guarantee it to stay in place. Of course it won't ruin anything and it will be easy to uninstall if needed in the future.

There is a round pad which slides to the bottom of this holder. It is also being hold in place by double sided tape.

Some armrest have a little rubber cover next to the corner of this adapter. Some also have a sliding button and it may collide. Check the photo with a red arrow.
These parts should be removed in order to fit the cup holder well. It is easier to make a little cutout on the print itself.

It was made for European BMW.

I guess it is possible to fit UK or other countries with a steering wheel on the right if mirrored. Didn't try though.

The one on the pictures is printed with Creality Ender 3 v2.
0.4 nozzle
0.2mm layer height
40% infill ( you may go smaller)
No Supports needed
Print Petg or other heat and UV resistant filament
The one on the photos was printed on a blue tape to have a little bit of pattern.