Stanley T. Cap 709ml

This is a model of the Stanley 709ml thermos lid, it is a larger than normal lid as the thermos has a larger diameter mouth.

The model is prepared to function as a lid to transport liquids inside the thermos, but it is not a starter spout, although it can be used in this way leaving the lid halfway up the thread without reaching the end.

It is designed with the thread and inclination of the same perfect, in addition, at the bottom we made a "channel" where you have to go an Oring, which is used to seal the end of the thread so that the liquid does not pass, because if not used, the friction of the metal with the plastic lets the water pass. If it happens to you that does not reach the end of the lower part (which has the thread) we have the solution, a kind of "washer" that is printed and placed between the upper and lower part, which makes the necessary separation between the two parts to seal well.

Recommendation: try to place the thermos upright or with a little inclination but not completely upside down, although the thermos does not leak, when putting the lid on (without forcing too much) the oring is placed against the metal and does not let the liquid pass through, but we clarify it just in case.

I hope this model that we have been making for some time for your thermos is useful for you.

Thank you! 🤗

Type of material:

PLA - although others can be used.