Surf Shop Birdhouse - No Supports needed/Two sizes & Prusa Mini Compatible

NOTE: COPYRIGHT PA1© - PERSONNAL USE ONLY. SUBSCRIBE TO MY PATREON TO GET ALL MY FILES FOR FREE, PLUS EXCLUSIVE MODELS AND A COMMERCIAL LICENSE TO SELL YOUR PRINTS. LINK TO PATREON :

https://www.patreon.com/PA1_MAKER

Here's another birdhouse to add to your collection!

Simply perfect for the summer that has just begun!

Cute, colorful, with a nice ibiscus flower on its side, the whole thing is absolutely gorgeous in my opinion.

For the whole birdhouse collection follow this link:

https://cults3d.com/en/design-collections/PA1_MAKER/birdhouses-garden-accessories

The design is very simple and easy to print/assemble. Most caracteristics of the precedent birdhouses are there, but there's a few minor differences.

MAIN FEATURES:

-100% support free

-Detailed and easy instructions in the form of exploded views.

-Individual parts for a nice, colorful print without the need of a special printer.

-Color Coded filenames for references and grouping parts together.

-Printable on a small printer (180x180) like the Prusa Mini.

-Also printable on a bigger printer with the instructions below.

WHATS DIFFERENT WITH THIS ONE:

-Draining holes at the back

-Rear ventilation hole, near the roof (that's why the gable is different at the back, there's no sharp point)

-You can use the same support now with two different sizes of birdhouses! Yep you read correctly! Two sizes, one support. Thanks to the multiple mounting holes on the bottom door.

If you use the birdhouse in its actual size (Prusa mini size), you just print all the stuff as it is.

If you want a bigger birdhouse, print everything at 133%, EXCEPT FOR THE SUPPORT. Keep it as it is.

You will notice two patterns of mounting holes on the bottom door. The smaller pattern, in the middle, will give the exact same pattern/hole sizes as the big one once it is scaled at 133%. So this is where you're gonna mount your support once the bigger birdhouse is done. No need for a bigger support, so both models can be installed on the same type of support.

The only thing: You will have to replace the (4x) M3x6mm screws to hold the door in place with (4x) M4x8mm instead.

The screws to mount the support on the door will stay the same (M4x10mm), same has we use usually.

INFO REGARDING THE SIGNAGES

Both ones can be printed with simple color changes. The color are indicated in the file names.
Again, If you are not familiar with color changes, don't be shy to send me a message. I will be pleased to help you as usual. Its very easy to do, and you don't need a special printer to do that.

So I guess that's it! Hope i did not forget anything.

If you have any questions, just send me a message!

Have fun!!!