Fast-Print Mobile/Cell Phone Stand

This fast-printing phone stand has been specifically designed to print in ‘vase mode’ (and 0.8mm line width) to allow for very fast printing and low filament usage, whilst maximising strength and stability.

#PHONESXCULTS

Key features:

• Very fast to print - Only takes around 90 minutes using an entry level printer, and 40 minutes using a more advanced machine (eg. high-speed CoreXY printer).

• Uses minimal filament.

• Strong and stable design.

• Easy to neatly route a data/charging cable via an integrated channel.

• NEW: In addition to the standard version, an XL version (for larger phones or those with cases up to 17.5mm thick) is now available to download.

• Doubles as an easy wrap-around cable storage solution (cable clip included).

I hope you find the design useful and I would love to see some photos of your prints if you want to share makes.

Also, please check out my other fast printing designs, and keep checking back or follow me, as I have more on the way soon.

PLEASE NOTE:
These files are provided for PERSONAL USE ONLY. It is prohibited to share or redistribute these files or any derivatives, or to use them for commercial purposes, including selling the printed models.

Copyright ©

#PHONESXCULTS

This model has been designed to print using ‘vase mode’. It is also possible to print the model in non-vase mode by using zero infill, zero top layers, and 1 wall. This could be useful for printing multiple models at a time on the same build plate.

The model has been designed to print best using a 0.8mm line width. I use a 0.32mm layer height, as I find this gives a good balance between print quality and speed.

As this model prints in ‘vase mode’, no supports or infill are required.

The cable clip should be printed in non-vase mode.

Please make sure your 3D printer is designed to work safely using whichever settings you decide to use.