WINDMILL VANE/WIND MILL VANE

Hello ami@s I have designed this windmill to decorate my roof, it does not produce electricity simply is decorative and moves and orients with very little wind (0.5m / s approx).need to buy 4 ceramic bearings measure 8mm x 22mm x 7mm and a PVC pipe plumbing 32mm outside diameter and 25mm inside diameter. To leave the mill well leveled print the whole rod and cut it until the mill is well balanced since the weight to leave it well balanced depends on the filler that is used, it is the only way that everyone can make the mill and have it perfectly balanced.

I leave photos of the section of the mill so that it is clearer where each piece goes. (ATTENTION THE MACHINE THAT YOU USE MUST BE PERFECTLY CALIBRATED SO THAT THE MEASUREMENTS ARE CORRECT AS THE ADJUSTMENTS BETWEEN THE PIECES ARE VERY VERY DEMANDING)

Thank you very much for seeing my design, if you have any doubt or problem contact me with confidence.

Bearing linkage size 8x22x7:

https://es.aliexpress.com/item/32834087124.html?spm=a2g0o.productlist.main.5.45c03807LnDh4i&algo_pvid=38ac7d73-5122-4130-8cf3-87b919a63300&algo_exp_id=38ac7d73-5122-4130-8cf3-87b919a63300-2&pdp_npi=3%40dis%21EUR%218.34%211.09%21%21%219.08%21%21%402100b77316892573175884625d0744%2110000006055677360%21sea%21ES%210&curPageLogUid=Y5Z65XYamVtP

To print the bearing housings you must stop the machine place the bearing and continue printing, so they will be completely inside the piece and will not give any failure. It is important to do it well because you can not go back in this step, I leave photos in the files.

The parts of the rotor, support and rod are glued although it is not necessary.

I recommend printing in ASA although PETG can withstand the weather well.

Only supports are needed to print the blades and the windmill support.

I STRESS THE IMPORTANCE OF THE MACHINE AND FILAMENT BEING PERFECTLY MATCHED IN SIZE, OTHERWISE THE DESIGN WILL NOT WORK.