Acetech Quark-M (Quark-R) to Umarex T4e X-tracer 50 tracer mount adapter

this mount makes it possible to mount a acetech quark R/M unit on a tracer mount that was made for the X-tracer 50, that can also simulate gun flashes making also usable with normal paint at low light conditions it doesn’t have to be pitch black. but I don’t think there is a tat you will see it’s effects on a open field in the middle of the day. but in a building this should be a different story even during the day. but of course it will be more noticeable how darker it’s the gun flash simulation works on the fact that it lightens up the gas cloud a paintball marker makes. so the more air volume is going out of the marker and how more it forms a cloud the bigger the blast effect is. note this really a short blast. so if you blink you will mis it haha. and some times cameras happen to mis the shot. but well that is why you have more than 1 rounds haha…

-
tracer options for 68 cal
you got for what I have seen now 2 options for the 68 cal markers

the ACETECH Quark-R (Quark-M) the Quark-M sits inside the tracer that is called the Quark-R. the unit can lighten up green and Red tracer rounds. and it can make a wide spectrum of colored gun flashes

the Umarex T4E X-tracer 68
mounts will me made on a later date, that might work for this

-

compatibility note
make sure you select the right mounting option since they all need to be costume made so that barrel alines with the tracer properly!
and select the correct tracer model!

make sure you got 1 of the X-tracer 50 tracer mounts so you can attach this tracer ring adapter so it will now work for Quark-R or M tracers.

and Acetech Quark-R tracer or Quark-M tracer unit.

also keep in mind that your safety “barrel plug” or barrel sock works with this set up

I will make a TIPX style of barrel plug that will fit this tracers and add it to the collection.

movie link:
https://youtu.be/Gj-XHxpkgTo
https://youtu.be/_P3jsdKkdq0
https://youtu.be/z_aTjp-OFms

-
Materials needed

1x O-ring 1mm CS, 40mm OD, used on the inside grove of the Quark-M front case

1x PVC binding cover 0.2mm thick. this is used to make a trace unit protector

print settings:
0.2 layer hight is fine
you can use the 8 layer walls and a 40% infill.
but personally I moved a bit over to solid prints just to give it more strength in case things go wrong on the field…

I recommend that you use the orientation I have placed the files in. it’s true it cost more supports this way but you will have good threats and that is want matters in the end.