Pac-Man Arcade Nostalgia

A Pac-Man art plate for those feeling nostalgic. Prints on a regular single color 3D printer by swapping the filament a few times during the print. Print starts with black filament then there are color swaps to dark blue, yellow, white, red, pink, cyan and then white filament. Check the included Prusa Slicer Project File to see exactly where I made my filament changes if you like :)

This is an easy color swap print! Anyone can print this print! Here is a video on how to do a color swap in Prusa Slicer: https://youtu.be/CtC5vAK94qA

I usually print art plates, signs and blueprints at 0.1mm layer height.
In this case we began with black filament, then a filament change to dark blue is performed at around 1.5 mm. Change to yellow at 1.7mm. A change to white at 2.6mm. Red at 3.10mm. Pink at 3.4mm. Cyan at 3.7mm and finally orange at 4mm.

I like to use 1 perimeter; in my opinion it helps details to show. This was printed at 100% infill. I recommend setting the infill angle to 0 or 90, it gives a better surface look for pictures and blueprints. I turn off the skirt in order to fit larger prints on the bed. You can try rescaling the model by scaling the model up or down uniformly and then independently raising or lowering the model's Z height to back to the original 4.2mm.