Grinder Barrel GRZ!

Grinder Barrel GRZ!

Compound:

• Lower cover Barrel CLEAN

• Lower Cover Barrel GRZ logo

• Lower Cover Barrel BioHazzard logo

• GRZ logo Barrel

• BioHazzard logo Barrel

• Drip Barrel

• Upper Cover Barrel

• Container Grinder Barrel

• Threaded body Strainer Barrel

• Crowbar Barrel

• Barrel Project

Ideal for storing, carrying and chopp grass! :P

You can print the parts you want, whit or whitout logo.

And you can try make this design whit embedded print in other color

For the lower cover you must print first "GRZ logo Barrel" then change color

filament and print "Lower Cover Barrel GRZ logo" whitout take out the first print.

The same way for the "Lower Cover Barrel BioHazzard logo", first print the logo then the cover.

Make sure to place the prints in the right coordinates (X;Y).

ATTENTION!

NOTE: very important to enable "z jump on retraction" to set up

"z jump height" to 1 mm, so the nozzle can avoid the previous print.

NOTE2: It's important that each printer and slicer are properly configured.

NO SUPPORTS NEEDED!

Hope you have fun printing my design :)

Let me know if you like this experiment by uploading your make! <3

Follow me on instagram @grz_id

Layer Height: 0.24

Infill: 10%

Wall thickness: 1.5

Material Temp: 210 (PLA from Print to Lot)

Bed Temp: 60

Flow Rate: 100%

Speed: 55

Suports: NO

Scrolling: Enable retraction and "Comb Mode" -> "All

Enable "Z jump on retraction

Z jump height: 1 mm