GHK GBB AUG Paddle Mag Release - BIG PADDLE ONLY!!! PIC 1

This is the BIG paddle Part (the one being pushed to release) Only !!! since I have 2 different paddles.

The Part that is outside the stock.

On the Pictures with more paddles, it is the bigger one. It is around 6-8mm Longer, and easier to use with Gloves.

The Inner part is ALSO needed.

Replaces (the Set) the original and the paddle can be used as an AK mag release, or be pushed rearwards with the hand when grapping the mag.

Original tube and spring needs to be reused!

Only for Airsoft and Only tested with GHK GBB AUG.

Drop in, Take care when pushing the tube in - I can push it in directly, but I have a well tuned Printer. If you overextrude I reccomend that you use a drill to clean up the hole.

The spring goes into this part through the hole, where the parts connect. This is that the original spring does not need to be modified in any way. See the pictures.

Do not fit the Snow Wolf AUG: It fits perfectly when with out of mag but when you load mag hook dosent retract.

Please do not share my designs - I costs a lot of time and Test Prints to get this far.

I Printed it in 0.1mm Layer, 4 outer walls, 20% Infill, because it looks good. You can change the layer height, but it will then not look as good.

Printed on the side and NO supports.

PLA can be used when it doesn't get too hot (until around 60) else ABS/ASA should be used.