Updated Wings for Battle City Duel Disk

This is an update for the wing files for eisenspider's fantastic duel disk model. For the rest of the pieces of the duel disk as well as instructions, please see his build here (https://www.thingiverse.com/thing:4598013). I just cleaned up the model a bit because for some reason there was a lot of artifacting and it was making it harder to finish. I also included files for solid wing pieces and made all the pieces a little thicker so I wasn't so worried about them breaking.

There is two versions for each piece, one titled "updated" and one titled "ledge". The ones listed as "updated" are cleaned up versions of the original files with the only changes to the mesh being I made them a bit thicker so they would be more sturdy. The ones listed as "ledge" have an overlapping piece as part of their construction to glue them together, because I had a very hard time getting them to glue properly with such little surface area. This should make them easier to build.

If you have any questions or suggestions on these please leave a comment! I am eager to see if these ledged pieces will work better. I intend to print a set when I have a chance. I know for sure the mesh works to print and doesn't artifact because I had to fix wing piece 1 when I was printing it because it was leaving really hard to fix scarring all over it.

Thanks to eisenspider again for the fantastic model!