Pug the Peacock

Pug the Peacock is a project that i have been working on for a long time, I started making this model december 2022, and showed the design on my tik tok in january 2023, but something always bugged me about it, and I left it sitting for a long time, until i started making my sassie pals series, and then it hit me that this design could be adapted to become a cute sassie pals. And its came out amazing!

I then spendt almost 2 days working on and off on the 3mf file and all that hard work also payed off, the results on my bambu x1-carbon printing it in 4 colors was stunning!

That 3mf file is of course included in this print, and you can print your very own colorful peacock! :-D

I also have a Patreon, If you are interested in getting more than one file at a time. You get my full catalog when signing up, with lots of files to print:
https://www.patreon.com/Sassiecat3d

Important when buying the design:
This is my design and copyight to me sassiecat3d, it's not to be used commercially or resold without my permission, the stl file is under the same clause, not to be re-sold or use commercially without my permission. You are welcome to contact me if you would like to know more. :-) You agree to these terms when you purchace this file.

This file has my logo on the bottom since its for personal use. If you want to purchase the file without the logo, you need to get the commercial version.

For buying the commercial version where you can print and sell copys of a physical 3d printed version, go here:
https://cults3d.com/en/3d-model/art/pug-the-peacock-commercial-version

I used a .4mm nozzle, .12mm layer height, I use 5% infill

No supports needed :-D It a fully print in place model!

Make sure your printer is all set with a good calibration and retraction before printing it.