Bookmark collection 3D print model

Just a miscellaneous bookmark collection complete with a stand and case, all easily 3d printed. There really wasn't a direction when these were designed aside from making them somewhat good-looking and easily 3d printable (no supports required).

Model units: mm

Tips on printing:

• Use an easy filament (PLA is best)
• slow print speed to a minimum (maintain first layer speeds for maximum quality)
• reduce line width to .2 - .3mm for greater detail (don't set it too low else you risk underextrusion-related failures)
• IMPORTANT: wait for the build plate to cool to room temperature before removing from the bed, else you risk the print warping immediately after removing from the plate (especially dangerous with malleable filaments such as PLA)
• using different bottom and top layer patterns can yield beautiful results but are tricky to get right

Tolerances for the case might need to be adjusted depending on your printer.