Fold 4 Slim Spen quick swap attachment

This is a quick swap add on for the Samsung Fold 4 S pen/Kickstand case.

You will NEED that official case or a copied one. (only tested on the official one)

And a Fold 5 S Pen.

This will allow you to mount the Fold 5 Slim S pen to the Fold 4 case.

There is a little slider that you slide down to pop up the s pen. Much like the oem case.
However there is no return spring. So you will have to manually slide up the nub when you replace the pen back in.

The slot is on the tight side to hold the pen in place. There is also tiny nubs that hold it into the slot.

Over time these little nubs and walls of the slot may wear out depending on the filament you use.
At that point simply print a new one.

Please view all the photos i provide.
You can see a small gap where this attachment slides into the oem case, ruffly 0.3mm top and bottom for clearance.

** license is for personal use only

https://youtu.be/PoNZd8DOQuw

Below is the casr you will need in order to use this

https://www.samsung.com/us/mobile/mobile-accessories/phones/galaxy-z-fold4-standing-cover-with-s-pen-black-ef-of93pcbegus/

If there is any confusion please message me.

Print settings

Print at 0.16mm or lower layer height.
I use bambu studio, you can print without support if you print infill/outer/inner wall order.
Other then that supports might be needed on the bottom hole for the slider.

Also remember some filament will shrink so you mint have to scale up 0.1 to 1%
Pla is a prefect fit for me. ASA is a little thigh but is fine for me.