KKFOS Cotton Candy Ray Gun Blaster Killer Klowns from Outer Space

Killer Klowns From Outer Space was one of the craziest cult-classic comedy / horror films of all time. An entire generation of children were impacted in some way by this film. The sight of a clown frightens half of them, while the other half are suddenly overcome by a ravenous desire for popcorn and cotton candy.

If you know, you know...

Our 3D Printable Cotton Candy Gun honors this hilariously bad movie. The KKFOS ray gun blaster is designed to mirror the one from the movie. Sure, you could go online and purchase a KKFOS cotton candy / popcorn blaster for anywhere from US $30-$55, but 3d printing and painting your own is soooo much more satisfying!

See Also: KKFOS Shorty the Klown by GP3D

Cotton Candy Gun - Print & Assembly
The blaster comes in three pieces for easy printing and building. The three STL files are:

• KKFOS Cotton Candy Gun - Back
• KKFOS Cotton Candy Gun - Middle
• KKFOS Cotton Candy Gun - Front

There is also a "Whole" file that was included for preview purposes in Cults3D. It is not meant for printing, but you're welcome to try if you like. I strongly suggest printing the three pieces separately, as it is far easy to print, paint, and build the individual parts.

Note that you will need supports on the Back piece, but not the Middle or Front.

Dimensions
At 100% scale and fully assembled, the Killer Klowns Ray Gun measures:

X = 6.3cm / 2.5in
Y = 15.1cm / 5.9in
Z = 10.9cm / 4.3in

If you like our KKFOS movie fanart paraphernalia, please check out our other GetPrinted3D Creations on Cults3D (including many more Classic / Horror movie themed items!)

• https://www.cults3d.com/en/users/GetPrinted3D/creations

IMPORTANT Copyright Info Unless otherwise noted, ALL GetPrinted3D designs are Copyright protected. When you purchase a file, you do NOT have the right to sell the file or printed model. Files may not be redistributed under any circumstances. The models are for personal and private use, and may not be sold commercially without the explicit written consent of GetPrinted3D.

You can obtain a Commercial Resell License to legally sell our designs here:
- Patreon.com/GetPrinted3D

Enjoy!

I'll lay these out one piece at a time, in order of easiest to print.

The Middle is quick and very easy. No supports are required and standard settings will do.

Layer Quality / Resolution: 0.2
Infill: 20%
Speed: 80mm/sec
Supports: No
Plate Adhesion: None

The Back piece (handle section) will require supports. Otherwise you can use basic, standard quality settings.

Layer Quality / Resolution: 0.2
Infill: 20%
Speed: 80mm/sec
Supports: Yes
Plate Adhesion: Brim

The Front section can print with or without supports, depending on how fast you want it to print. With 0.12mm layer height and 40mm/s speed (as recommended below), you shouldn't need supports. Or, you can speed it up and use 0.16-0.2mm layer height with supports.

Layer Quality / Resolution: 0.12
Infill: 20%
Speed: 40mm/sec
Supports: No
Plate Adhesion: None