Sky CotL Rythm Greeter Cosplay Mask

Inspired by the Season of Rythm, Greeter mask in Sky: Children of the Light.

Contains 2 types with 4 variations:
TYPE: Solid Piece
This is the entire mask as one solid object for printing

TYPE: 2 Part (Color separated pieces) Top and Beak.
This is the mask separated into the "top" and "beak" parts for printing in two colors if desired.

VARIATIONS:
These variations are different vision hole options.
No vision holes - So you may cut your own vision holes
Circle Vision holes - multiple circles have been cut out like a mesh
Bar Vision holes - A straight bar has been cut out like a welder's mask
Two Block Vision - Two rectangular blocks have been cut out (Like "Iron Man")

You will need to add ELASTIC STRAPS to hold the mask on to your head, and ADHESIVE to glue the parts together. (I recommend high temp hot glue, two part epoxy, or a PLA glue gun.)
I also recommend using upholstery foam or styrofoam to hold the mask a bit up and away from your face for it to rest on the wearer's head and fit properly. The vision holes may not work without it.

Please use the following measurements as a guide when printing, and measure the wearer's head prior to printing to ensure you get a good size for wearing, everyone's sizes are a little different. Especially if you have a wider or bigger head!

This was modeled around my own head as reference:
About 21 in / 53.5 cm diameter
About 9 in / 23 cm from top of head to chin

This mask is VERY WIDE and should be "one size fits all" for most teen and adults.
It may need to be scaled down for children (at it's default scale it may be too large.)

DEFAULT MEASUREMENTS:
Please see measurements.png included in the files

With the mask in upright orientation (as if being worn)
Height: 266.0691 mm
Width: 272.3207 mm
Depth: 234.6877 mm

If you purchase this file and believe it needs modifications before printing please contact me so I can update the files for you!~
This file is intended for large printers, but if you need me to chop it up into smaller pieces for your printer, just message me with your print bed size and I'll happily cut it into smaller parts you can glue together!

**Any changes made to update this file for easier printing or use will be redistributed to buyers free of charge, simply show proof of ownership and allow for me to contact you or you can contact me on any of my social media!

Contact Info:
twt: https://twitter.com/nathahniel
e-mail: nathahnielartist [!at] gmail.com
Etsy: https://www.etsy.com/shop/Nathahniel
Ko-Fi: https://ko-fi.com/nathanier
Gumroad: https://nathahniel.gumroad.com/

RULES:

DO NOT sell or distribute this .stl file
DO NOT upload this file to sites like thingiverse, sketchfab, etc.
You may send these .stl files to an artist to request or commission an edit. The artist is not required to purchase the file if you are providing it.
You are welcome to use this for crafts other than fursuit heads.

SELLING BASED ON THESE FILES:

You may sell up to 20 finished prints of this file per year.
You may not sell the digital files or reupload them elsewhere.

unknown