Star Wars Verpine Shatter Rifle (VSR-10)

THIS IS A WIP.

UPDATE 11/22/2023 Folder has been changed out with the new components for the Wraith X and AEG/Spring versions.

I HAVE NOT PRINTED YET, BUT HAVE TRIPLE CHECKED ALL THE MEASURMENTS.
IF YOU HAVE A CHANCE TO PRINT BEFORE ME, LET ME KNOW OF ANY ISSUES.
I WILL HAVE A WORKING PRINT BY THE END OF AUGUST/MID SEPTEMBER 2023.
PRINTS ARE IN A ZIP FILE LABLED “VERPINE SHATTER RIFLE” (3MF).

This is a kit for the VSR-10 rifle. It is based off the Star Wars Verpine Shatter Rifle/Sniper Rifle. It is built around the Wolverine Bolt and Wraith X Stock. There is a spring version included (LH and RH), and an AEG M4 Buffer Tube Stock for springers and tank users. It utilizes a 430MM inner barrel (500mm if below mod not used).

There are 2 grips:
• Snipe’s grip which utilizes the stock. There are 2 base plates, one for the Wraith x (solid) and one with a pass through for HPA lines.
• Stubby Grip which does not use the stock.

There is a TDC mod built-in with 4 rotary Dials. Mando Style, Empire Style, Rebel Style, and a blank for your design. The TDC uses M3x5mm ball point set screw to allow the dial to lock in place, but still allows for adjustment in the field without tools. There are up to 60 positions for precision hop.

This is also designed with the intent of using the Straight Pull Mod with the Wolverine Bolt. There is an included bolt handle. All you need is 3”x.5” spring with low-medium tension. There are videos on how to do this on You Tube.

There is an End Barrel Mod labeled “Where Did That Come From”. It goes inside the end barrel in a specific order. There are dots on the first 4 pieces that symbolize what order they are from top to bottom. Fifth in line (no dots) goes inside first, then stacks in descending order (5, 4, 3, 2, 1). You will need 2 O Rings (8mm ID x 10mm OD, 8mm ID x 15MM OD), which will go on the end of your inner barrel after installing the Hop Barrel and Mid Barrel (along with hop up). The thicker O Ring goes on first roughly 110-115MM from the end of the inner barrel. The thinner O Ring goes roughly 25-30mm from the end of the inner barrel. I say roughly because you want the End Barrel to sit snuggly against the O Rings as they act as a stabilizer and seal.

The outer barrel is in 4 parts: End Barrel and End Cap, Mid Barrel, and Hop Barrel. You can remove the Mid Barrel for a shorty version which utilizes a 200MM inner barrel (275MM if above mod not used).
There is also a false mag that acts a as a storage mag for 3 12g Co2 cartridges and holds a 2.5 and 4 allen keys.

I have included a list of screws, nuts, and springs needed in the zip file.

This will replace all but the following:
• Inner Barrel
• Cylinder (I am using the Wolverine Bolt Plus Cylinder)
• Bolt handle if not using the straight pull mod or using spring
• Trigger if not using included trigger
• Trigger Block
• Hop Up
• Hop Up Block
• Mag and Mag Release