SD Card Holder - DLSR Camera Lens

I designed this SD Card holder for photographers and photography lovers in mind, although anyone can use it. It was designed to appear as a DSLR 35mm Camera Lens. It is really easy to assemble and print with minimal supports.

Build instructions:
1. Part A should be glued to the bottom of Part B (not the open side).
2. The adjustment wheel should only be slid onto the open side of Part B (not glued).
3. Part C has grooves that align to part B, and then the should be glued together. The adjustment wheel should spin freely once the glue has dried.
4. Print 12 of the SD Card holder sleeves and 2 of the SD Card Sleeve Stands.
5. The SD Card Sleeves should easily slide into between the extrusions on the SD Card Sleeve Stands and spare pieces of filament (1.75mm) should fit to hold them in place so that that can pivot out for easy access.
6. The two SD Card Sleeve Stands should be able to screw into each other and then into the top.

You can add a little hot glue to the cut ends of the filament pieces holding the SD Card Sleeves so they don't slide out if you'd like.

I would really appreciate it if you shared your builds if you paint them! If anyone would like, I can extend the lens to be able to fit more SD Card Stands. Hope you enjoy!

All the parts were printed with Matter Hacker's 1.75mm purple, white, or black PLA
nozzle: 195C
bed: 60C
print speed: 50mm/s
Infill pattern : Gyroid
Infill density : 5%
Wall Count : 2

The only part printed with supports was Part B with the opening facing upward. The X/Y distance for my supports are 1.2mm, and the Z Distance is 0.4mm.

The SD Card Sleeves were all printed with the opening facing upward.