BEAR PAW KEYCHAIN

Take advantage of this incredible opportunity to acquire a 3D printable file of an innovative cartoonized minimalist keychain! With this file in hand you can create your own unique and personalized bear paw.

The minimalist design of this bear paw ensures a clean, sleek aesthetic. With smooth lines and streamlined details

Here are the suggested 3D print settings for the Bear Paw STL file with dimensions of 7cm x 5.5cm:

Material: It is recommended to use PLA (Polylactic Acid) or ABS (Acrylonitrile Butadiene Styrene) to print the skates. These materials are widely used in 3D printing and offer a good combination of durability and printability.

Layer Height: Set a layer height of approximately 0.2 mm. This value will result in good resolution and a smooth finish for the skates.

Infill: A 20% to 30% infill will be adequate to provide the skates with the necessary structure and strength.

Print speed: For best results, set a moderate print speed, typically between 40 mm/s and 60 mm/s. This will help ensure good layer adhesion and accurate detail.

Nozzle temperature: Nozzle temperature can vary depending on the type of material you are using. For PLA, a recommended temperature range would be 190°C to 220°C. For ABS, adjust the nozzle temperature between 220°C and 250°C.

Print base: Use a suitable print base surface, such as a heated base with specialized 3D printing adhesive tape or a glass plate with a properly applied adhesive. This will help ensure good material adhesion during printing.

Please note that these settings may vary depending on your specific 3D printer and individual preferences. It is always recommended to run a few test prints and make any necessary adjustments to get the best results.