Korg NTS-1 eurorack adapter

This 18HP adapter will integrate Korg NTS-1 into eurorack so that all its connectors are facing front. The adapter will mount the main board of the NTS-1 at 90 degree angle.

In addition to printing the adapter you need the following:

14 short male-female jumper cables
3,5mm stereo jack connector (6mm outer diameter)
3,5mm stereo cable (cut and solder to the jack connector)
Two-sided tape to attach the NTS-1 main board onto the back support plane

The full setup:

1. Mount a 3,5mm stereo jack onto the panel
2. Solder a short audio cable with 3,5mm jack onto its pins. Make sure to leave enough cable so you can connect the jack to headphone out of the NTS-1 main board.
3. Use two sided tape to fix the main board to angle support. It's best to put the tape onto the NTS-1. Note that the design can acommodate various thicknesses of tape. Fix the tape further back if it doesn't fit.
4. OPTIONALLY: Use two sided tape to ensure the adhesion of the front plate of the module. Note that the tape must be quite thin in this case.
5. Connect the user interface board and the main board with jumper cables
6. Connect the stereo jack to headphone out. Note that you may have to bend the pins and isolate the jack with shrink wrap of equivalent.

Powering the module can be done by the micro-USB port, but it should be possible to power it from the eurorack power supply by soldering jumper cables to suitable places on the mainboard (NTS-1 has several HW revision so it's possible that the newer ones have even dedicated solder points for that..

Printer brand:
Artillery

Printer:
Artillery Sidewinder X1

Rafts:
No
Supports:
No
Resolution:
0,2
Infill:
100%
Filament brand:
Devil Design

Filament color:
Black

Filament material:
PETG