Fox Phone Holder / Keyring

• Toy
• Decoration
• Phone stand
• Keyring

If you want to sell prints of this models you can buy a commercial license here:
https://cults3d.com/en/3d-model/gadget/fox-phone-holder-keyring-commercial-license

Check out more models from Phone collection
https://cults3d.com/en/design-collections/c47/phone

or Animals collection
https://cults3d.com/en/design-collections/c47/animals

A Fox is in normal version and with holes where you need to put a 1.75mm filament as eyes *- you can also leave it with holes as it is *

Around 7mm of filament is needed. I put a longer string inside and then cut with a knife (carefully to not damage the model or yourself). If you want to install already cutted filament cut it with around 60dgr angle for best look
Pliers may be usefull to help installing the filament

Each with full body or with space for a phone (6-16mm - as in file names and on the bottom of models)
Phone will be at 16° angle. Should work with horizontal and vertical placing

To resize the models use the equasion:
'Needed space (in milimeters)' divided by 'model number' multiplied by 100% = 'Needed model size in percent'
For example if you need more stable 16mm you can take 10mm version resized to: 16 / 10 * 100% = 160%

To make a Keyring use a model of your choice and add there a keyring addon (Fox_keyring-addon). Both models should be in the exact same position in your slicer to be sure that they will merge properly
Then select both models and merge them (right click menu)
Keyring models are with a 'frame', a flat surface that will not be printed. This way it is easy to set it in the right spot - Ignore model 'errors' and DO NOT try to 'fix' the model
After merging you can easly resize or rotate the model if needed

UPDATE 05 I 2024
Added versions for 6-9mm phones

UPDATE 08 IV 2024
Added version with holes, to be used with 1.75mm filament as eyes
Updated PHONE models
Now they are with numbers on the bottom to show what size it is after printing it
Changed Keyring addon a little - should work better
Added 'mm' to numbers in file names to avoid rare confusions

Printed with 0.4mm nozzle
0.1mm layer height
2 walls
NO supports needed
7% gyroic infill (or no infill when used Prusa Slicer or simmilar that will add an inner bridges for supporting when needed)