TEALIGHT PUMPKIN FAMILLY 2023 EDITION! - 6 DIFFERENT MODELS

NOTE: COPYRIGHT PA1© - PERSONNAL USE ONLY. SUBSCRIBE TO MY PATREON TO GET ALL MY FILES FOR FREE, PLUS EXCLUSIVE MODELS AND A COMMERCIAL LICENSE TO SELL YOUR PRINTS. LINK TO PATREON :

https://www.patreon.com/PA1_MAKER

Here's the 2023 edition of the pumpkin familly!

6 different models, all easy to print.

You can scale them in all axis. You can also scale them in one axis only, to change the shape of the pumpkin (i.e in the Z axis) to have a higher pumpkin, but remember to scale the lid too!

All parts have been tested and all parts are already placed in the right orientation.

Individual parts design, No multi color printer required, can be printed on any type of 3d printer.

Three types of stem are also included!

IMPORTANT NOTES:

-You must glue one center ring under each lid, in the small groove.
This will prevent the lid from moving and the lid will be perfectly
aligned with the pumpkin's body.

-Use at least 3 walls. This will prevent the infill to be visible when
the tealight is on.

-DO NOT use lightning infill. This will cause some areas to be darker than others. You don't want that.

-The stem is almost a snap fit part. I didnt use glue for my pumpkins, and all the stems are very tight in their cavity... But if you have a bit of over extrusion or elephant foot, the stem may not fit. In this case, scale down the stem by 1% and try again. You may need to glue it in this case, depending on your settings.

-3 of the pumpkins requires a few supports on the mouth. Those are
Pumpkins no.002, no.003 and no.006. Use tree supports, with
"touching build plate only". You can use support blocker on their lid
to prevent any supports in the small groove under the lid, or split
the model file and print the lid separately. The reason the lid and
the pumpkin are in same file, is because not every lids are the
same. Some are different depending of the pumpkin's shape. If you
are not familiar with support blockers or the split command, send
me a private message. I will be pleased to help you!

That's it folks! Everything is super easy to do and they are not very long to print, so you'll have plenty of time to print an entire army since Halloween!

Have fun!!! Post your makes!

2022 Pumpkin familly:

https://cults3d.com/en/3d-model/home/halloween-pumpkin-familly