WITCH'S BREW CANDY BOWL - No supports needed!

NOTE: COPYRIGHT PA1© - PERSONNAL USE ONLY. SUBSCRIBE TO MY PATREON TO GET ALL MY FILES FOR FREE, PLUS EXCLUSIVE MODELS AND A COMMERCIAL LICENSE TO SELL YOUR PRINTS. LINK TO PATREON :

https://www.patreon.com/PA1_MAKER

A classic witch's cauldron, which is in fact a large bowl, big enough to hold a lot of candies!!!

The cauldron has a diameter of 190mm and a height of (roughly) 150mm.

The broth is the lid of the bowl, and you can lift it by grabbing the large bone on the side.

A witch's broth wouldn't be one without a few eyes! So I have included two models, straight and angled to add a little bit of diversity. They can also be scaled up or down to obtain different sizes, just make sure you are scaling all the parts and using the right ones. More details about the eye assemblies in the instructions.

The design is really easy to print. Even the twisted handles, which have a specific base design to make them really easy to print.

Everything prints without supports, and all the parts are already placed in the right orientation for printing.

The design is made of individual parts, so no need for a multicolor printer.

I strongly suggest to use a brim on the small parts, like the iris and the pupils.

NOTES:

Use a small layer height for the eyes, like 0.12mm or 0.08mm to have the best results. I also used a small layer height on the broth, to have nice and round bubbles... You can also use adaptive layers if you prefer.

I recommend 3 walls and at least 15% infill.

In any case, if you are experiencing some troubles with the files or the design, send me a private message. I will try to help you as much as i can, as i always do.

Have fun! Keep printing!!! :)