Box

I made a box with a sliding shutter to keep my memory sticks, adapters and flash drives all in the same place.

-the model consists of a box in two parts that can be printed separately or at the same time, I recommend the placement as in the attached photo, the dimensions of the box are 16x7x10 cm then you will need to print 11 pieces of the file called (shutter5) and 1 more piece of the file called (piece1_5) this is the end of the shutter and includes the handle and closure, I printed them in vertical position, once these printed you will need with the help of a cutter to go over the shape of the side glued to the bed so that the pieces enter smoothly without "hooks between them" both along and turning between them.

Ender 3 v2 printer

1.75mm filament

205º bed

nozzle 55º

print speed 90%

the two halves of the box I recommend printing separately and with the sides upside down on the bed.

-the shutter parts I recommend printing vertically for a burr issue one or all that is up to you, this way you will only have to go over the bottom of the parts to get a good bond, you should remove the burrs from the bottom until the shutter works perfectly.

Assembly, take one part of the box and place it on the table, then place the assembled shutter in its housing with the piece of the handle in front and facing outwards, then place the other part of the box and press to join the two halves.