Granblue Fantasy: Versus - Narmaya Nagamaki

This model is designed for Narmaya cosplay from Granblue Fantasy series.

It is divided into 5 main parts, sheath, blade, tsuba, handgrip, and accessories. The handgrip is cut into 4 parts, tsuba 2 parts, and 5 parts for blade and sheath to fit in a printer with a printer size of 200mm x 200mm x 200mm.

There is a picture with parts labeled to their file names in the preview section which you can refer to.

I also include the uncut version of each part just in case you need it.

A tunnel with a diameter of 10mm is punched on the handgrip for alignment and bone installation purposes. While for the blade, a tunnel with a diameter of 3mm is punched on it for the same purposes. You can use anything with a similar diameter for this purpose.

I will include a "peg" file which is a cylinder with a diameter of 9.5mm just in case you need it on the handgrip. To print a cylinder with a diameter of 3mm is nearly impossible. I will suggest getting a 2mm iron rod which is widely used as amature in sculpting for the tunnel on the blade.

To avoid support applied in the tunnel which is hard to remove in the post-printing process, I cut the model at an angle that can lay on the bed yet minimize the use of support. You can refer to the orientation shown in the preview section for a better view.

For the sheath, please do not join all the parts before making sure it can house the blade. You may need some sanding and scraping as warping may occur during the printing process.

To install all the parts together, there is a peg that passes through the tsuba and inserts into the cavity on the handgrip. Make sure all the parts can house each other before applying any glue to join the parts.

You will need to perform an ito outer wrap on the handgrip using a cloth strip or cotton ribbon. You will need a red cloth strip for the acc too.

For scaling, please use the same scale factor for all the parts.

Cheers and Happy Printing!

Dimension: 1390mm x 112.12mm x 75mm