XO Dice Battle

The game consists of a square plastic board with 25 dice: half of them are white and the other half are black.

Each player takes their dice and adds one to the board in each round. At the end, we check if any player has 5 pieces of the same color in the same row, be it horizontal, vertical, or diagonal.

If that's the case, that player is the winner. If there aren't 5 pieces in a row, we look for four, and so on.

I am open to creating different sizes or a more aesthetically pleasing model if needed. Please leave your requirements in the comments.

For the Original Prusa i3 MK3S+ using PLA with the settings provided, I recommend the following settings for a good print:

Layer Height: 0.3 mm

Infill: 20%

Print Speed:

I'd start with a standard speed of 50-60 mm/s. You can adjust as needed, based on your experience and the results.

Nozzle Temperature:

For PLA, I recommend starting at 205°C to 215°C. The exact optimal temperature often depends on the specific PLA manufacturer.

Bed Temperature:

60°C is a good starting point for PLA on the Prusa MK3S+.

Supports:

You shouldn't use them at all.

Bed Adhesion:

((Only for older printers with poor adhesion)): A 4-8 mm wide "brim" can help improve adhesion, especially if the parts have a small contact area with the bed.

Wall Thickness:

0.8 mm to 1.2 mm is a good starting point for most applications. With 0.8 mm, you'd have 2-3 lines on the walls, depending on the nozzle diameter.