Little Cities - Football Stadium

Little Cities is a 3D Printable toy series where miniature buildings and vehicles are stored within a purpose designed case until ready for play. Once play begins simply unfold the case and attach the miniature buildings to the outside of the case to create a mini play set. Each case will be themed with mini vehicles to print as well. The cases can also interlock so you can expand your little cities playset as I develop and release new Little City themed cases.

This set is the Football Stadium!!!
And even comes with miniature tour bus. And yes, the windmill.

Please check out and follow my profile page to see which Little Cities have already been released.

Some have been released for free on Printables. Just search for my profile page neil3dprints.

Note - This is not a MMU print. Simply print the parts in the appropriate colours and glue them together.

As this is part of a series I will release a Little Cities every week until the full collection has been released. There are 43 Little City sets in total.

Please note some of the parts may cause a choking hazard, so these 3D printed toys are not recommend for children under the age of 6.

Want to stay up to date with my designs then check out my instagram or twitter.

https://www.instagram.com/neil3dprints/?hl=en

https://twitter.com/NHengist

Print instructions

This is not a MMU print. Simply print the parts and assemble them together.

Please refer to the images for assembly instructions.

The case I printed at 0.2mm layer height and 0.15mm for all other parts.
Refer to the file names to see if colour changes (CC) are required and for what layer heights to apply the colour changes.

The vehicle wheels print in one. Be patient and gentle to loosen them so they can turn. Also use a little glue to attach the vehicle parts together while ensuring the wheels still turn.

Any questions or queries just send me a message and I will get back to you when I can.

This is not a MMU print. Simply print the parts and assemble them together. You will need modelling glue and/or superglue.

Please refer to the images for assembly instructions.

The case I printed at 0.2mm layer height and 0.15mm for all other parts.
Refer to the file names to see if colour changes (CC) are required and for what layer heights to apply the colour changes.

The vehicle wheels print in one. Be patient and gentle to loosen them so they can turn. Also use a little glue to attach the transit van together while ensuring the wheels still turn.

Any questions or queries just send me a message and I will get back to you when I can.