Shelmet,Karrablast,Escavalier,Accelgor Evolution -FAN ART - POKÉMON FIGURINE -POKEMON

This is "Lotad,Lombre,Ludicolo Evolution" from Pokémon series
I will be releasing my work on daily basis, some may even be free! so please follow and keep your eye on my updates !!cheers

PLEASE CHECK THEM OUT(OTHER 3D MODELS FROM THE SAME DESIGNER)!

Shelmet is a bivalve or snail-like Pokémon. Its gray shell resembles a knight's visor, with a coiling spiral of its shell further back. The shell has protrusions on the underside, which it apparently uses as legs. Its inner body is pink with a long, puckered mouth, and green markings below its eyes.

Karrablast is a round, bipedal Pokémon with a primarily blue carapace that comprises a horn at the tip. Its black face has a teal patch on its forehead, a fanged mouth, and eyes with orange pupils and yellow sclerae. Its ridged underbelly, or plastron, is yellow, and its stubby arms and legs are black.
Accelgor is a Pokémon which has a large pink head reminiscent of a helmet that is curled in the back. Green stripes run from its eyes to the top of its head, and there is a black star-like marking or hole on the front. Its eyes are hidden in a shadowed crevice in its head. The rest of its body is covered by a blue, cloth-like membrane, which keeps Accelgor from dehydrating, with ribbon-like extensions at the top of its back. Its arms, when crossed, portray an aggressive mood.
Escavalier is an insectoid Pokémon with a head sporting the red horsehair crest of a knight's helmet, with a visor underneath it. Its shoulders have large, round metal ridges, from which its thin black arms extend. The arms are tipped with red-striped protrusions resembling jousting lances. Its face and torso are bare of armor, but its lower body is concealed within a swirled gray shell with a red spike on the underside, which was presumably the shell of a Shelmet.

*This model require minor support to print with FDM .
*to have a better print result I would suggest to print this model in angle where the front surface facing upwards to avoid support structure in FDM prints, for DLP & SLA should be fine.