R3D Supports for DOTA 2 - WITCH DOCTOR

READ AND UNDERSTAND DESCRIPTION BEFORE DOWNLOAD!

!!!ATTENTION!!! NO STLs included.
This is LYT files to use with Lychee slicer but you MUST HAVE the original model files . LYT files are useless if you don't have the original STLs. The LYTs CAN NOT be opend without the model files in the scenes.
Put all the LYTs and the STLs in the same folder. Follow the link to the original creator/model and download the STLs before trying to use these supports.

Rosengren3D got the pleasure to support PRiNGs "DOTA 2 - WITCH DOCTOR" and the model can be found here:
https://cults3d.com/en/3d-model/game/dota-2-witch-doctor
And is also found here:
https://boosty.to/pring/posts/21b0d2da-eba3-4b63-943c-24aca9ed509c?share=post_link

A lot more beautiful models are found at PRiNGs profile (https://cults3d.com/en/users/PRiNG/creations) please check them out and maybe give an extra thumbs up.

This model is in one piece and is rotated to put as little marks of supports as possible on the front of the mini. It is a highly detailed miniature and it was impossible not to put a few supports on the model not attached to the raft.

The Base is a round nonscenic base and will be very good if turned upside down and printed with a FDM instead. It will be alot cheaper then do it with a SLA printer. But it is included, supported and test printed to make sure it works with a SLA printer as well.

This is only LYT files for the DOTA2-Witch Doctor and the Base. You can NOT open the files without having the original STLs found by the link above. Mke sure you can locate both "WitchDoctor.stl" and "Base.stl" locally otherwise these LYTs can't be opened.

The best way is to put the LYT and the STL in the same folder. The LYTs are named after the STL files.

Picture1: The 2 LYTs put in one print
Picture2: The printed,cleaned and curred Witch Doctor
Picture3: The printed Witch Doctor and it's supports
Picture4-5: Close ups of the Witch Doctor
Here you can watch a video of me removing the supports:
https://youtu.be/kUteMS2SbjA

I can't promise the LYTs will work as well for you as they did for us but if you feel like you need more supports it is easy to add or alter the supports settings using Lychee slicer.

This is the second release of a PRiNG model support file and we are hoping to get the chanse to do more.

It is printed with 0.04mm layer height using a Photon Mono 2K and a mix of Anycubic standard and flexible resin.